10.1.1 Refrigerating unit control panel

The control panels of the cooling system located in the engine room and in the main helm station have the following functions:

  1. “ESC” key
    Allows exiting the menu (6).
  2. “COOL” Key
    When the relative LED is lit, cooling mode is active.
  3. Decrease key “▲”
    This key allows decreasing a value and scrolling the menu.
  4. “HEAT” Key
    When the relative LED is lit, heating mode is active.
  5. Increase key “▲”
    This key allows increasing a value and scrolling the menu.
  6. “MENU” Key
    This key allows selecting the desired temperature by means of key (5) or (3).
  7. “ENT” Key
    Confirms the data set.
  8. “I” Key
    This key enables switching the system on (LED lit) or off (LED off) without disconnecting it.
  9. Display
    Displays the data.

At first start the chiller unit will operate according to the parameters set.

NOTE

For further information on use and maintenance, please refer to the manufacturer’s manual.

CAUTION

It is strongly recommended NOT TO CHANGE the factory setting. This is possible only in exceptional cases and with the help of RIVA staff and Service Departments.

CAUTION

The signal of any alarm implies a failure in the operation of the system. INVESTIGATE and ELIMINATE THE REASON FOR THE FAULTY OPERATION before restarting the system.
Refer to the specific manual or refer to the Service Department.