7.6.2 Battery check (accumulators)
Carry out following checks:
Terminal inspection
-
Check that the battery containers are clean and dry and that the terminals are coated with silicon grease and properly fastened. Clean and grease as required. Inspect at least every 6 months.
- Identify positive and negative cables, prior to connecting (connect the positive terminal first and then the negative, in order to avoid sparkles).
DANGERBatteries may be subject to explosion hazard, with subsequent risks of serious personal injuries. Do not use open flames, smoke, cause sparks or use arc-welders in the area where batteries are located. Do not disconnect battery cables when the generator is running.
Battery acid may cause serious injuries. Wear safety goggles, gloves and protective clothing.
Do not wear any bracelet, ring or any other jewel when operating on batteries.
In case of contact with battery acid, wash the contaminated part with fresh water for at least 15 minutes and address to a doctor.
DANGER
Always remove the negative terminal (-) for grounding connection first and connect it last.
DANGER
Operations on batteries must be performed by qualified personnel.
CAUTIONCheck the condition of the batteries, making sure there are no traces of electrolytic corrosion on the poles and connection terminals; if corrosion is detected, contact servicing and replace the affected elements.