6.4.1 Toilet operation



The bathroom toilets are made of ceramic and their control panels contain two backlit buttons:

  1. Button “BEFORE USE”
  2. Button “AFTER USE”

After 2 minutes of service the backlit buttons 1 and 2 switch OFF and the device sets to energy saving mode.
Approaching the hand to the panel, the backlight will be restored and the operation panel.

In case of alarm for a full tank, the two button icons are illuminated permanently.

To clean the surface of the panel, you can turn it OFF by pressing briefly one of the two buttons. This prevents the accidental activation of the toilet control.

NOTE

For further information on use and maintenance, please refer to the manufacturer’s manual.

CAUTION

We suggest not to use the residential function of the toilet, as the water inside the toilet could splash out and wet the floor due to the yacht’s rolling.

CAUTION

Other than organic waste, only very thin toilet paper can be discharged into the sea toilets. Paper tissues or handkerchiefs and sanitary napkins may clog and damage the sanitary system.

CAUTION

Make sure that toilets are electrically powered and that the black water system is operating before using them.

CAUTION

Forcing the toilet discharge can cause overfill of the tank.

CAUTION

The full tank condition is indicated by the red icon light.

CAUTION

The disabling of toilet drain protection can cause the tank to overfill.