6.1.3 Hot fresh water system

Water is drawn from the tank by mean of an autoclave pump and delivered to the water heaters, which heat it.
The autoclave pump keeps the circuit under pressure continuously.
The thermostatic valves installed on the water heaters allow the setting of the hot water temperature at the taps.
In order to use hot water, it is necessary to:

The water heater and autoclave magneto-thermal s, in the main electrical panel located in the engine room, are in the ON position;
Ensure that a power supply is connected (generator or shore);
Make sure the user battery breaker is set to ON.

The water heaters are powered at 230V AC, taken from shore or from the on board power generators.
By means of a distribution manifold, the hot water is conveyed to the following uses:

VIP cabin bathrooms;
Service bathroom;
Guest cabin bathrooms;
Owner’s cabin bathroom;
Galley sink;
Stern shower;
Bow shower.

NOTE

For further information on use and maintenance, please refer to the manufacturer’s manual.

WARNING

Water heaters are not storage heaters: wait for it to come up to temperature.