7.16 SHAFT SUPPORT BUSHINGS

Periodical checks

• Check the shaft backlash (1) trying to move the shaft on a side back and forth to verify the backlash of the shaft supporting bushing (2).

Assembly/disassembly

• If the propeller shaft (1) shows backlash, the water lubricated neoprene bushing (2) could be worn out; in this case replace it.
• Remove completely the antifouling to reveal the screwdriver screws (3) which lock the bushing positioned.
• After the propeller (4) and the shaft (1) have been disassembled, by means of a plastic tube with a slightly smaller diameter, pull out the bushing (2).
• For reassembly, repeat the above-mentioned operations in reverse sequence.
• Do not use grease between propeller shaft and bushing.
  Remember to fasten the screws (3).
  

CAUTION

For spare part request contact the CUSTOM LINE After Sales & Service Department.

CAUTION

Remember to retighten the fixing screws (3) of the bushing on the shaft support. Never use grease or other lubricant between propeller shaft and Neoprene bushing.